Majosoft's Hobby Site

1)

2)

view A - A

Click on this picture
 and it will be enlarge.

See the black rubber ring =>

Put your material on the table

Push the little plate to it.

Turn on the screw.

Turn the screw until your work cannot move anymore.

Check it , and you can start engraving.

Selfmade Product Table 2

Click on the picture
 and it will be enlarge.

This table is made of wood and plastic.
Make peaces of 50 mm width and 60 mm width and make them together on a wooden plate like this.

The nut like a letter T.

Selfmade Product Table 3

Click on the picture
 and it will be enlarge.

Cutt through A - A

Click on the picture
 and it will be enlarge.

This is a product table of Gravograph.

It works simple and fast.
Turn the handle and your product will be safely.

This cut through will show you how this table works.
The handle centre is not the turn centre. So when you turn the handle the bar will push down.

Cut through A -A

Click on the picture
 and it will be enlarge.

This is an easy an perfect tool to use on a product holder here above.
I have made a lot of brass plates with a slot in the middle.
When you have a round product , its not so easy to pich.
Unlock screw A and move all the plates (B) to your product, turn screw A on.
Now close your product holder tight.