How to make Clamping Devices

Product tables

Selfmade Product Table 1

This product table is very , very , very easy to make and it is so handy.

1)

2)

Selfmade product holder for an engraving machine

view A - A

Selfmade product holder for an engraving machine

Click on this picture
 and it will be enlarge.

Selfmade product holder for an engraving machine
cutt view Selfmade product holder for an engraving machine

See the black rubber ring =>

Selfmade product holder for an engraving machine
Selfmade product holder for an engraving machine

Click on the picture
 and it will be enlarge.

here are a few pictures about
How to work with this table

Selfmade product holder for an engraving machine
Selfmade product holder for an engraving machine
Selfmade product holder for an engraving machine
Selfmade product holder for an engraving machine
Selfmade product holder for an engraving machine

Put your material on the table

Push the little plate to it.

Turn on the screw.

Turn the screw until your work cannot move anymore.

Check it , and you can start engraving.

Selfmade Product Table 2

Selfmade product holder for an engraving machine

Click on the picture
 and it will be enlarge.

This table is made of wood and plastic.
Make peaces of 50 mm width and 60 mm width and make them together on a wooden plate like this.

The nut like a letter T.

Selfmade Product Table 3

Selfmade product holder for an engraving machine

Click on the picture
 and it will be enlarge.

Cutt through A - A

Selfmade product holder for an engraving machine

Click on the picture
 and it will be enlarge.

This is a product table of Gravograph.

It works simple and fast.
Turn the handle and your product will be safely.

This cut through will show you how this table works.
The handle centre is not the turn centre. So when you turn the handle the bar will push down.

Product Holder

Selfmade product holder for an engraving machine

Cut through A -A

Selfmade product holder for an engraving machine
Selfmade product holder for an engraving machine

Click on the picture
 and it will be enlarge.

This is an easy an perfect tool to use on a product holder here above.
I have made a lot of brass plates with a slot in the middle.
When you have a round product , its not so easy to pich.
Unlock screw A and move all the plates (B) to your product, turn screw A on.
Now close your product holder tight.

Clamping 1

klemblok_met_kikker1_k

This product is very handy. You can loss your product without to lose your reference. When the product is on the thin part, you can cut through your product whitout hitting your machine table.

klemblok_met_kikker2_k

Clamping 2

kikker1_k
kikker1_seperate_k