This stepper is 2.9A with a torque couple of 12 Nm
Bipolare driver. For a steppermotor with 4,6, or 8 wires.
Powersupply 80Vac - 250 Vac.
No need for an aditional powersupply. Just an isolation transformer for safety.
400,500,600,800,1000,1200,1600,2000,2400,3200,4000,5000,6000,6400,8000 or10.000 microstep per revolution ( with a 1.8 degree steppermotor )
0.45 A - 7.8 A peak amps output Automatic current reduction to 70%
Internal cooling with fan.
Overheat protection Short circuit protection Solid casting Input selectable between Step/Direction or CW/CCW
Step frequentie > 400 Khz.
A useful tip
Look out. When you have a machine with cast iron guide lines you can not move it faster than 3 meters per minute.
When you have hardened steel guide lines you can not move it faster than 10 meters per minute.
When you have roller guide lines you can move it faster than 60 meters per minute.
First i change the Xax screwthread for a ball screw. Thats very easy on this machine.
I place the stepper direct on the ballscrew.