Fly Cutter netherlands

slagkop_frees_001

How you can make this Fly Cutter on a lathe with Y ax

slagkop_frees_005

Use normal steel with 6 sides
It has a diameter of 30mm ( smallest sides )

slagkop_frees_002

Makes it round 16mm  and 35mm long

slagkop_frees_003

Chamfer the edge

slagkop_frees_004

And cut it off

slagkop_frees_006

Place the Y ax on your X support and clamp your product.

Place a milling cutter in your chuck

slagkop_frees_007

makes the front in an angle

slagkop_frees_010

make a slot in the same angle.

The width is 0.03mm bigger than the flycutter toolbit.

slagkop_frees_012

Now you are ready on the lathe.

Make the surface blue with a feltpen and make a marker line.

slagkop_frees_013

Make 2 centers with a distance of 10 mm and drills the screw holes.

Now it’s ready.

slagkop_frees_001

It’s time to use.