Lathe product strike

IMG_5970
IMG_5951

Lathe product strike:

When you must make several axis with the same length, than you need a product strike.

IMG_5936

i use brass as material.

IMG_5937

measure the diameter of the head stock hole.

Make your product
0.1mm smaller

IMG_5938

Drill a hole of 12.1mm

IMG_5941

Make 2 centers in the middle and drill them 3.3mm for m4 ( do not make the screw threat yet.

IMG_5943

cut your product with an angle in to two pieces. You can do this also with a saw.

IMG_5945

 

IMG_5946

drill one piece bigger with
4.3mm

IMG_5947

in the other you tapped m4

IMG_5951

in the upper piece you make a small screw to fix the ax

IMG_5970

put it in the head stock of your lathe.

IMG_5972

turn on the screws. You shall see that with a little strength your tool is fixed.

IMG_5971

now it’s ready to use.