\n"; echo " \n"; echo " \n"; echo " \n"; echo " \n"; echo "
\n"; echo " \n"; echo " \n"; echo " \n"; echo " \n"; echo "
\n"; echo " \n"; echo "

Proxxon MF70 conversion
to CNC

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_023\"

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_002\"

\n"; echo "

Sorry, but i have made a few pictures.
This is the Y ax. I made all the distance blocks ( blocks between stepper and machine ) off aluminium 100mm X 60mm X4mm.

\n"; echo "

The 4 centers in square are for the steppers, The centers at the edge of the circle are for the mount of the block on the machine.
The circle is a hole for the stepper.

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_005\"As you can see , there is on the stepper also a circle.

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_003\"On a drilling machine drill the holes through the material and make a center at the bottom. then take a smaller drill and drill the small holes.

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

 

\n"; echo "

Cut the block to the right length and mount them on the machine.

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_013\"

\n"; echo "

For the X ax i have take a new piece of leadscrew. You can take also the original leadscrew.

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_014\"

\n"; echo "

This is the Z ax. I have made this block 56mm width and i make also 2 little caps in the block for the screws.

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_015\"

\n"; echo "

 

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_016\"

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_017\"

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_019\"

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_020\"

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_021\"

\n"; echo "

\n"; echo " \n"; echo " \"proxxon_mf70_cnc_022\"

\n"; echo "
\n"; echo " \n"; echo "
\n"; echo "